Hitachi RPIM - Removal of the Inlet and Outlet Air Thermistors

10.6.2 Removal of the inlet and outlet air thermistors
Inlet air thermistor
Nº Part
1 Tie
2 Cable clamp
3 Thermistor
N O T E
To disconnect and remove the appropriate thermistor,
previously see the chapter corresponding to the wiring
diagrams in this Manual.
Nº
Part
1 Location of the air inlet thermistor
2 Rear cover
Remove the screws securing the rear cover of the unit.
Disconnect and remove the thermistor.
10 Servicing
311
SMGB0063 rev. 1 - 10/2010
10