Equipment
Equipment Remarks
Cleaning water manifold
Depending on the type of unit to be cleaned, use
a duct-type, built-in 2-way type, wall type or
ceiling type manifold. The lower part of the Ø120
hole must be covered with a piece of felt to insert
the nozzle of the gun
Cleaning water manifold kit Built-in 4-way
Cleaning water manifold kit
Parts
Material Remarks Quantity
Container with access panel Vinyl chloride sheeting
1 mm thick, with a 0.3 mm access
panel
1
Bracket A Stainless steel 8
Sheeting A Vinyl chloride sheeting
1 mm in thickness, with support B
and magnet
1
Sheeting B Vinyl chloride sheeting
1 mm in thickness, with support B
and magnet
1
Sheeting C Vinyl chloride sheeting
1 mm in thickness, with support B
and magnet
1
Sheeting D Vinyl chloride sheeting
1 mm in thickness, with support B
and magnet
1
Motor panel Vinyl chloride sheeting 1 mm in thickness with magnet 1
Motor flange Vinyl chloride sheeting 1 mm in thickness, adhesive tape 1
Connection panel Vinyl chloride sheeting 1
Gloves Rubber 1
Sling 1 m 4
12 Maintenance notes
367
SMGB0063 rev. 1 - 10/2010
12
To Next Page
Loading...
