Item Specification Comments
Transfer speed 10 Gbps N/A
Connector type LC N/A
Cable Optical OM3, OM2 MMF
cable
N/A
Network switch L2 or L3 switch Should comply with
IEEE802.3ae
Switch cascading Maximum: 5 switches or
fewer
Minimum number of
cascading switches is
recommended.
MAC address Per port (xed value) Factory setting: World Wide
Unique value. Cannot be
changed.
Maximum transfer unit
(MTU)
1,500, 4,500, 9,000 bytes
(Ethernet frame)
Jumbo frame, MTU size
greater than 1500
Link aggregation Not supported N/A
Tagged VLAN Supported N/A
IPv4 Supported N/A
IPv6 Supported Note the following
precautions:
■
When iSCSI Port IPv6 is
set to Enabled, if the
IPv6 global address is
set to automatic, the
address is determined
by acquiring a prex
from an IPv6 router.
■
If the IPv6 router does
not exist in the network,
the address cannot be
determined. As a result,
an iSCSI connection
might be delayed. When
an iSCSI Port IPv6 is set
to Enabled, verify the
IPv6 router is connected
to the same network,
and then set IPv6 global
address automatically.
iSCSI specications
Appendix D: Data and power cables
Hitachi Virtual Storage Platform F700 Hardware Reference Guide 76