Hitachi VM-2300A User Manual

DISPLAY BUTTON
Pressing the “DISPLAY” button lets you check several special displays in the viewfinder.
Battery Level and Linear
Time Counter
LINEAR TIME COUNTER
Shows length of tape run in hours, minutes and sec-
onds. Press “DISPLAY” button to select the linear
time counter display.
Load a cassette into the camera/recorder and perform
recording or playback; the counter indicates the elapsed
time.
NOTES:
¢ The linear time counter does not operate when
nothing is recorded on the tape.
@ Counter changes to 0:00:00 when cassette is ejected.
MEMORY
When the linear time counter with memory indication
appears in the viewfinder, a tape that is being rewound
automatically stops when the counter reads approxi-
mately 0:00:00’. This is useful if there is a section of
tape you want to review immediately after recording or
if you want to return to the same point several times in
a row.
1. Press “DISPLAY” button until the linear time coun-
ter is displayed.
2. Press “MEMORY” button. (The indicator ““M” ap-
pears in the viewfinder.)
3. Start playing or recording a tape.
4. At the point you want playback to start, press
“RESET/T-160" button to reset the counter to
**0:00:00"’.
5. Continue to play or record.
6. Press “STOP” button.
7. Press ‘““REW” button. The tape will be rewound to
the preselected point, at approximately “0:00:00”
indication.
NOTE: The tape will also stop approximately at
“0:00:00” during fast forward mode.
1st press 2nd press
Battery Level and Time-
Remaining Display
3rd press
Removes Display
“DISPLAY” Button
“REW” Button
“STOP” Button
“DISPLAY” Button | “MEMORY” Button
“RESET/T-160” Button
E27

Hitachi VM-2300A Specifications

General

Brand	Hitachi
Model	VM-2300A
Category	Camcorder
Language	English