Hitachi VM-2300A - Attaching Telephoto or Wide Angle Lens

To
remove
and
replace
the
front
case
of
DC
camera
light
™@
To
replace
the
front
case,
pass
the
lamp
through
the
hole
of
the
reflection
plate
then
attach
the
upper
hooks
to
the
DC
camera
light,
and
then
attach
the
lower
hook
to
the
DC
camera
light
while
pressing
the
tab.
@
To
remove
the
front
case,
press
and
hold
the
tab,
then
remove
the
front
case.
NOTES:
¢
Do
not
touch
the
lamp
directly
with
your
fingers.
It
may
shorten
its
service
life.
©
When
the
lamp
is
replaced,
or
when
the
front
case
of
the
DC
camera
light
is
removed,
make
sure
the
front
case
is
attached
to
the
DC
camera
light
properly.
ATTACHING
THE
TELEPHOTO
OR
WIDE
ANGLE
LENS
1.
To
remove
lens
hood,
put
hand
flat
against
lens
hood
and
turn
it
counterclockwise.
2.
Remove
both
caps
of
the
telephoto
or
wide
angle
lens.
3.
Screw
the
lens
into
the
threads
on
the
front
of
video
camera/recorder
lens
assembly.
NOTE:
Auto
focusing
will
not
operate
correctly
when
the
telephoto
or
wide
angle
lens
is
attached
to
the
video
camera/recorder.
£47