Hitachi VM-2300A - Page 6

IMPORTANT
SAFETY
INSTRUCTIONS
FOR
AC
ADAPTOR/ICHARGER
1.
E6
Save these instructions — This page contains
important safety and operating instructions for AC
Adaptor/Charger Model VM-AC64A.
. Before using AC Adaptor/Charger, read all instruc-
tions and cautionary markings on (1) AC Adap-
tor/Charger, (2) battery and (3) product using
battery.
. Also read all instructions on pages 4 and 5.
. Caution — To reduce risk of injury, charge only
rechargeable battery, VM-BP65 or VM-BP64.
Other types of batteries may burst causing personal
injury and damage.
. Do not expose charger to rain or snow.
. Use of an attachment not recommended or sold by
the battery charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
. To reduce risk of damage to electric plug and cord,
pull by plug rather than cord when disconnecting
charger.
. Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
. Do not operate charger with damaged cord or plug
— replace them immediately.
10.
11.
12.
13.
An extension cord should not be used unless ab-
solutely necessary.
Use of improper extension cord could result in a risk
of fire and electric shock. If extension cord must be
used, make sure:
A. That pins on-plug of extension cord are the same
number, size, and shape as those of plug on
charger.
B. That extension cord is properly wired and in
good electrical condition; and
C. That wire size should be met below:
Minimum :
AWG size Length of extension cord (feet)
18 Equal to or less than 100
16 Equal to or less than 150
Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way; take it to a qualified serviceman.
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required. In-
correct reassembly may result in a risk of electric
shock or fire.
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance or
cleaning.