Hitachi WL200 Series - Appendix PROFINET Object List

62
“b” Function
A
B
Defaults
Func.
Code
Name
Description
Initial data
Units

Ambient
temperature
setting
Set range is,
-10 to 50 C


40
C

Watt-hour
clearance
Two option codes:
OFF
ON (press STR then clear)


00
-

Watt-hour display
gain
Set range is,
1. to 1000.


1.
-

Start frequency
Sets the starting frequency for the inverter
output, range is 0.10 to 9.99 Hz


0.50
Hz

Carrier frequency
Sets the PWM carrier (internal switching
frequency), range is 2.0 to 10.0 kHz


2.0
kHz

Initialization mode
(parameters or trip
history)
Select initialized data, five option codes:
Initialization disabled
Clears Trip history
Initializes all Parameters
Clears Trip history and initializes all
parameters
Clears Trip history and initializes all
parameters and EzSQ program


00


Country for
initialization
Mode 1, Mode 0, Mode 3


01


Frequency scaling
conversion factor
Specify a constant to scale the displayed
frequency for  monitor, range is 0.01 to
99.99


1.00


STOP key enable
Select whether the STOP key on the keypad is
enabled, three option codes:
Enabled
Disabled always
 Disabled for stop


00


Restart mode
after FRS
Selects how the inverter resumes operation
when free-run stop (FRS) is cancelled, three
options:
Restart from 0Hz
Restart from frequency detected from real
speed of motor (freq. matching)
Restart from frequency detected from real
speed of motor (active freq. matching)


00


Automatic carrier
frequency
reduction
Three option codes:
Disabled
Enabled, depending on the output current
Enabled, depending on the heat-sink
temperature


01
-

Dynamic braking
usage ratio
Selects the rate of use (in %) of the
regenerative braking resistor per 100 sec.
intervals, range is 0.0 to the value calculated
by the value of b097.
If the connected resister’s allowable range is
narrower then above range, the resister’s
range is prior.
0%: Function disabled
>0%: Enabled, per value


0.0
%

Stop mode
selection
Select how the inverter stops the motor, two
option codes:
DEC (decelerate to stop)
FRS (free-run to stop)


00
