Version 1.1, 08/2013. Copyright 2012 Hitron Technologies
21
Version 1.1, 08/2013. Copyright 2013 Hitron Technologies
21
Hitron CGN3 User’s Guide
When you turn on the CGN3, the LEDs light up in the following order:
1 POWER
2 DS
3 US
4 STATUS
The LAN LED lights up as soon as there is activity on the LAN ports, the
WIRELESS LEDs light up once the wireless network is ready, and the USB LED
lights up once a connected device on either USB port is detected.
WIRELESS
(2.4GHZ)
Off The 2.4GHz wireless network is not enabled.
Green, steady The 2.4GHz wireless network is enabled, and no
data is being transmitted or received over the
2.4GHz wireless network.
Green, blinking The 2.4GHz wireless network is enabled, and data
is being transmitted or received over the 2.4GHz
wireless network.
Bi-color Wi-Fi Protected Setup (WPS) is in operation on the
2.4GHz wireless network.
WIRELESS
(5GHZ)
Off The 5GHz wireless network is not enabled.
Green, steady The 5GHz wireless network is enabled, and no data
is being transmitted or received over the 5GHz
wireless network.
Green, blinking The 5GHz wireless network is enabled, and data is
being transmitted or received over the 5GHz
wireless network.
Bi-color Wi-Fi Protected Setup (WPS) is in operation on the
5GHz wireless network.
USB Off No USB device is connected to either USB port.
Green, steady A USB device is connected to one of the USB ports,
and is not transmitting or receiving data.
Green, blinking A USB device is connected to one of the USB ports,
and is transmitting or receiving data.
Table 3: LEDs
To Next Page
Loading...
Need help?
General
