Hiwin MG Series

To Next Page

To Previous Page

Assembly

Assembly instructions

Linear Guideways

GW-04-0-EN-1910-MA

5.3.2.2 Mounting the cover strip without a mounted block

Fig. 5.25 Cover strip with finished ends and distance L

Size Distance L

[mm]

15 5.0

20 8.0

25 9.5

30 10.0

35 10.0

45 11.0

55 12.0

65 14.5

Table 5.2 Dimension L

of cover strip end

A. Positioning the cover strip

X Clean the profile rail using a suitable cleaning agent (see Section 7.1).

X Place the cover strip on the profile rail.

X Maintain the distance L

in accordance with Table 5.2.

B. Clamping the cover strip

X Clip the cover strip onto the profile rail, over a length of approx. 15 cm.

X Press down the fold of the cover strip on the reference side of the profile rail.

X Press down the second fold on the opposite side.

Fig. 5.26 Mount cover strip

We recommend using the HIWIN assembly/disassembly tool to ensure correct mounting of the cover strip.

Information on this can be found in Section 11.2.

NOTE

Hiwin MG Series - Page 24