To Next PageTo Next Page
Need help?Do you have a question about the HNI Panel System and is the answer not in the manual?
General| Brand | HNI |
|---|---|
| Model | Panel System |
| Category | Indoor Furnishing |
| Language | English |
Describes opposing return panel configuration for stability.
Describes single-sided return panel configuration for stability.
Specific steps for VH panel to corner connection.
Specific steps for VH panel to panel connection.
Instructions for installing trim at the end of a panel run.
Procedures for installing trim at panel intersections.
Installing trim for VH panel to corner connections.
Installing trim for VH panel to panel connections.
Installing the top cap clip for frameless glass panels.
Securing the top cap extrusion for frameless glass panels.
Steps for installing the glass panel into the top cap extrusion.
Attaching end caps to the top cap extrusion.
Installing the power pole and J box assembly.
Routing the power harness for cable in-feed.
Installing ceiling plates and top caps for power poles.
Connecting the in-feed cable to the power block.
Overview of electrical configuration and component identification.
Diagrams illustrating electrical wiring configurations.
Procedure for powering the last panel in a run.
Details on using power and pass-thru harnesses.
Steps for removing power blocks and receptacles.
Guidelines for routing cables at panel junctions.
Instructions for removing the in-feed cover.
Steps to disconnect swivel joints and remove tabs.
Routing the in-feed connector through the base rail cover.
Procedure for reassembling the swivel joint.
Connecting the in-feed connector.
Reattaching the in-feed cover after installation.
Assembling the full end support panel.
Attaching anti-dislodgement brackets to the panel frame.
Connecting the end panel support to the worksurface.
Instructions for assembling support legs.
Installing the center support bracket for worksurfaces.
Attaching worksurface to panel support brackets.
Installing the worksurface bracket kit.
Installing a different type of center support bracket.
Attaching flat brackets to worksurfaces.
Installing corner support brackets for worksurfaces.
Determining the correct location for countertop brackets.
Steps for installing countertops.
Guidelines for hi-low countertop applications.
Instructions for installing overhead shelves.
Installing an optional shelf divider.
Attaching mounting brackets for overhead cabinets.
Securing overhead cabinets with retaining clips.
Positioning the overhead cabinet onto mounting brackets.
Final steps to secure the overhead cabinet.
Installing the hook plate for sliding doors.
Attaching the hook bracket for sliding doors.
Continued installation of the hook plate.
Installing the bottom rail assembly for sliding doors.
Installing the top rail assembly for sliding doors.
Attaching anti-dislodgement brackets for sliding doors.
Installing door stops and connecting to top track.
Connecting the sliding door to the bottom track.
Installing the front door stop.
Attaching the sliding door handle.
Connecting a door panel into an 80" high panel run.
Converting door orientation from right to left hand.
Installing the lower threshold for panel doors.
