TM-258 267 Page 10 Handler 140
4-9. Installing Wire Spool And Adjusting Hub Tension
When a slight force is needed
to turn spool, tension is set.
1/2 in.
Tools Needed:
Installing 8 in. (203 mm) Wire Spool
Installing 4 in. (102 mm) Wire Spool
When a slight force is needed
to turn spool, tension is set.
Retaining ring used
with 8 in. (203 mm)
spool only.
Adapter used with 8 in.
(203 mm) spool only.
803 012 / 803 013 -B / Ref. 802 971-C
Align locking hole in
spool with locking pin
on spool hub.
To Next Page
Loading...
