3-1
Section 3
INSTALLATION
3.1 Pre-Installation Requirements
3.1.1 Required Tools
When installing the Discovery, a tool kit that includes the following items is required:
• Assortment of both flat-bladed and Phillips screwdrivers
• Assortment of needle-nose and diagonal cutting pliers
• Socket drivers (full set including 1/4", 3/8", 7/16", 1/2" and 3/4")
• Open-end wrenches (full set including 3/8", 7/16", 1/2", 9/16", 5/8" and 3/4") and an
adjustable wrench
• Hex driver (Allen wrench) set including sizes 1/16", 5/64", 3/32", 7/64", 1/8", 9/64", 5/32"
3/16", 7/32" and 1/4"
• 24 Inch Digital Level (099-0269)
• Oscilloscope and digital multimeter
• Survey meter (Victoreen model 450P or equivalent)
• Measuring tape, approx. 3.7 meters (12 feet)
• Beam alignment tool (TLS-00080)
• X-ray test pattern (099-0715)
• Step Wedge Penetrometer (099-0716)
• Aperture Alignment Pin (099-0111)
• Aperture Alignment Block (099-0145)
• X-Ray Leakage Test Tool (099-0566)
3.1.2 Required Documentation
The following documents are required:
• The Radiation Measurement Report (CSD-0042-F07)
• Discovery Technical Manual (this manual 080-1085)
• FDA Form 2579
To Next Page
Loading...
