53
OPERATION
STARTING THE ENGINE
Control Page
Side-Mount Control Type .......... 56
LHT Type (tiller handle)
1. Put the emergency stop switch clip
in the emergency stop switch, and
attach the emergency stop switch
lanyard securely to the operator or
to the operator’s PFD (Personal
Flotation Device).
The engine will not start or run
unless the emergency stop switch
clip is in the emergency stop
switch.
The emergency stop switch clip
and emergency stop switch lanyard
system is a safety device that will
stop the engine if you fall away
from the controls while operating
the boat.
Always attach the emergency stop
switch lanyard securely to the
operator or to the operator’s PFD
before starting the engine.
2. Check the position of the gearshift
lever. It must be in the N (neutral)
position for starting.
The engine will not start if the
gearshift lever is in the F (forward)
or R (reverse) position.
EMERGENCY STOP SWITCH
EMERGENCY
STOP SWITCH
CLIP
EMERGENCY STOP
SWITCH LANYARD
N (neutral)
GEARSHIFT
LEVER
31ZZ36130.book Page 53 Tuesday, July 22, 2014 10:21 AM
To Next Page
Loading...
