78
SERVICING YOUR OUTBOARD MOTOR
MAINTENANCE SCHEDULE
Follow the MAINTENANCE SCHEDULE table and service your outboard motor accordingly. Please note, a claim for
warranty coverage will not be denied simply because the maintenance schedule for your outboard motor was not
followed. However, any part(s) that fails specifically due to lack of maintenance, or improperly performed maintenance,
would not be covered under the Distributor’s Limited Warranty.
(1) Lubricate more frequently when used in salt water.
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and are mechanically proficient. Refer to the
Honda shop manual for service procedures.
(3) For professional commercial use, log hours of operation to determine proper maintenance intervals.
(7) Replace the anodes when they have been reduced to about one third their original size, or if they are crumbling.
Each use After use
First month
or
20 hrs.
Every 6
months or
100 hrs.
Every year
or
200 hrs.
Every 2 years
or
400 hrs.
Refer
to page
Engine oil Check level o 83
Change oo 85
Gear case oil Change o (2) o (2) —
Engine oil filter Replace o (2) —
Timing belt Check-adjust o (2) —
Throttle linkage Check-adjust o (2) o (2) —
Idle speed Check-adjust o (2) o (2) —
Valve clearance Check-adjust o (2) —
Spark plug Check-adjust/Replace o 87 – 88
Propeller and cotter pin Check oo99
Anode metal (Outside engine) Check o 98
Anode metal (Inside engine) Check o (2) (7) —
Lubrication Grease o (1) o (1) 89 – 90
Fuel tank and tank filter Clean o97
Thermostat Check o (2) —
REGULAR SERVICE PERIOD (3)
Perform at every indicated month or operating
hour interval, whichever comes first.
ITEM
31ZZ36130.book Page 78 Tuesday, July 22, 2014 10:21 AM
To Next Page
Loading...
