208
uuOperating the Switches Around the Steering WheeluAuto High-Beam
■
Manual switching between high-beam and low-beam
If you want to manually switch the headlights between high beam and low beam,
follow either of the procedures below. Note that when you do this, the auto high-
beam indicator will turn off and the auto high-beam will be deactivated.
Using the lever:
Pull the lever towards you for flashing the high beams then release it or push the
lever forward to the high beam position.
u To reactivate the auto high-beam, follow either of the procedures below and
the auto high-beam indicator will come on.
• Pull the lever towards you and hold it over two seconds then release it.
• Turn the light switch to and then to AUTO when the lever is in the low beam
position.
Using the light switch:
Turn the light switch to .
u To reactivate the auto high-beam, turn the light switch to AUTO when the
lever is in the low beam position, the auto high-beam indicator will come on.
20 2EX JSS (KE KG)-32TYF6000.book 208 ページ ２０２０年３月６日 金曜日 午後６時５８分
To Next Page
Loading...
