Honda E - Wipers and Washers

210
uuOperating the Switches Around the Steering WheeluWipers and Washers
Controls
Wipers and Washers
The windscreen wipers and washers can be
used when the power mode is in ON.
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, AUTO, LO, HI)
Move the lever up or down to change the
wiper settings.
■
Washer
Sprays while you pull the lever towards you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
■
Windscreen Wipers/Washers
1Wipers and Washers
NOTICE
Do not use the wipers when the windscreen is dry.
The windscreen will get scratched, or the rubber
blades will get damaged.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
NOTICE
In cold weather, the blades may freeze to the
windscreen.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
If the wipers stop operating due to an obstacle such
as the build-up of snow, park the vehicle in a safe
place. Rotate the wiper switch to OFF, and set the
power mode to ACCESSORY or VEHICLE OFF, then
remove the obstacle.
a MIST
b OFF
c AUTO
d LO: Low speed wipe
e HI: High speed wipe
f Washer
20 2EX JSS (KE KG)-32TYF6000.book 210 ページ ２０２０年３月６日 金曜日 午後６時５８分