648
Power System Won’t Start
Checking the Procedure
When the (Ready) indicator does not come on and does not appear on
the driver information interface, check the following items and take appropriate
action.
Checklist Condition What to Do
Check if the related
indicator or driver
information interface
messages come on.
appears Removing a charge connector. Set the power
mode to ACCESSORY, then to ON.
appears
Charge the High Voltage battery.
2 Charging P. 562
appears.
2 Driver Information Interface Warning and
Information Messages P. 130
appears.
uMake sure the keyless remote is in its operating range.
2 If the Keyless Remote Battery is Weak
P. 649
The (Power System) indicator comes on.
Have your vehicle checked by a dealer.
The transmission system indicator blinks and appears.
The power system can be activated as a
temporary measure.
2 If the Transmission System Indicator Blinks
along with the Warning Message P. 660
Check the brightness
of the interior lights.
The interior lights are dim or do not come on at all. Have the 12-volt battery checked by a dealer.
The interior lights come on normally. Check all fuses, or have your vehicle checked by
a dealer.
2 Inspecting and Changing Fuses P. 669
Check the Security
System Alarm
indicator.
When the Security System Alarm indicator is blinking, the power
system cannot be turned on.
2 Security System Alarm P. 189
1Checking the Procedure
If you must start the vehicle immediately, use an
assisting vehicle or booster battery to jump start it.
2 If the 12-Volt Battery Is Dead P. 651
Do not hold the POWER button for more than 15
seconds.
20 2EX JSS (KE KG)-32TYF6000.book 648 ページ ２０２０年３月６日 金曜日 午後６時５８分
To Next Page
Loading...
