4 MENU SETTINGS
41
Setting the lawn mower operation
Homing setup
Home screen J [2.Lawn setup] J [4.Homing setup] J
[1.Passage width]
You can set where the lawn mower moves in relation to
the boundary wire as it goes back to the docking station.
NOTE:
- This setting must be set to a value lower or equal
than the lowest width value that is set for any
mowing start point setting. For details on the
mowing start point settings, see “Mowing start
point” (M page 33).
Passage width sample table
Setup level Passage width
0 4 in. (10 cm)
1 10 in. (25 cm)
2 12 in. (30 cm)
3 14 in. (35 cm)
4 16 in. (40 cm)
5 18 in. (45 cm)
6 20 in. (50 cm)
7 24 in. (60 cm)
8 28 in. (70 cm)
9 32 in. (80 cm)
10 36 in. (90 cm)
-
The fi eld strength varies depending on the length of the
boundary wire. The fi eld becomes weaker with a longer
boundary wire, and stronger with a shorter boundary wire.
-
When the value is high (by avoiding moving along the same
path), you can avoid creating wheel tracks in the grass.
- The numerical values of this table are for reference
to return the lawn mower to the docking station
along a straight line.
- The numerical values may differ depending on the
actual conditions.
TIPS
Use as big a passage width as possible so to
reach the area quickly.
1
Enter a number setting.
2
Press the H button.
17:01 Fri
Passage width
Passage width
Max 10Min 0 1
Menu screen
To Next Page
Loading...
