90 CT40/CT40 XP Mobile Computer Series User Guide
About Transferring Files via USB Connection
If you plan on using a USB connection to transfer files to the mobile computer,
make sure you set the USB connection to allow file transfers. To learn more, see
Configure USB Connection and Transfer Files on page 23.
Install Software Apps with AutoInstall
Important: The mobile computer must have power for the entire length of the install process or
it could become unstable. Do not attempt to remove the battery during the process.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Honeywell Settings > Provisioning mode.
3. Tap the toggle button to turn Provisioning mode On.
4. Save the Android application file (*.zip or *.apk) in one of the following folders
on the CT40 mobile computer:
• Internal shared storage\honeywell\autoinstall
Files saved to this folder for installation, do not persist when a Full factory
reset or Enterprise data reset is performed.
• IPSM card\honeywell\autoinstall
Files saved to this folder for installation, do not persist when a Full factory
reset is performed. However, the software does persist if an Enterprise data
reset is performed.
5. Swipe up from the bottom of the Home screen to access all apps.
6. Tap AutoInstall Settings and Enable Autoinstall .
7. Tap Packages Upgrade from the AutoInstall Settings screen.
If required by the app, the computer may automatically initiate a reboot before
starting the installation process. When the installation is finished, a message
appears or the unit finishes rebooting and the lock screen appears.
8. Once installation is complete, turn Provisioning mode Off.
Note: Some updates do not require the computer to reboot before installation.
Optional microSD Card Method
The mobile computer comes equipped with a microSD card socket. You can install
an upgrade from a microSD card you insert in the computer.
Important: The CT40 must have power for the entire length of the install process or it could
become unstable. Do not attempt to remove the battery during the process.
To Next Page
Loading...
Need help?
General
