Honeywell CT40 - Add a Scan Setting Profile

CT40/CT40 XP Mobile Computer Series User Guide 45
Notification Settings
Use the Notification Settings to configure how your computer responds when you
scan a barcode.
Notification Settings
Add a Scan Setting Profile
To create a scan setting profile for a custom app on the computer:
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Honeywell Settings > Scanning > Internal Scanner.
3. Tap in the upper right corner of the app screen.
Same symbol
timeout
Set the minimum buffer time in seconds before the scanner reads
the same barcode. This can be adjusted to prevent inadvertent
scans of the same barcode if the code is left in the scan field longer
than the Decode Timeout limit. The default same symbol timeout is
1000 seconds.
Disabled
Setting Description Default
Setting Description Default
Good Read Notification Enables or disables a good read notification. The
notification consists of a green blink of the Good Read
LED, a short beep, and an optional short vibration.
Enabled
Bad Read Notification Enables or disables notification of a failed scan. The
notification consists of a red blink of the Good Read LED,
an error beep, and an optional short vibration.
Disabled
Vibrate On Notification Enables or disables whether the computer vibrates when
there is a good or bad read.
Disabled
Package Verification Package verification automatically stores the package
images from the near sensor to determine the context in
which the barcode was read. This data can be used as proof
of delivery and can be uploaded to Honeywell or customer
cloud using SSClient or customer-specific software.
Select the check box to turn the Package Verification
setting on.
Note: This setting is only available on models with dual
cameras.
Disabled
Package Verification Max
Folder Size (MB)
The maximum folder size allowed for the folder that stores
Package Verification images. Images are stored in
honeywell\ImageCapture\PackVerf_Images.
200 MB
Pkg Verify High Quality
Image Save
Enable this option to add new images and delete old
images when the maximum folder size is reached. If this is
not enabled, new images will not be stored until files are
removed by the user.
Disabled