Honeywell DC33XB - Display Parameters Set up Group; Calibration Group; Status Group; Table 3-13 Display Group Function Prompts

Configuration
38 UDC3300 Basic Model: DC33XB User Manual 12/00
3.14 Display Parameters Set Up Group
Table 3-13 Display Group Function Prompts
Function
Prompt
Lower Display
Function
Name
Selections or
Range of Setting
Upper Display
Factory
Setting
DECIMAL
Control Loop 1 Decimal
Place
XXXX
XXX.X
XX.XX
X.XXX
ATTENTION
Auto-ranging will
occur to whichever decimal
place has been selected.
XXXX
TEMPUNIT
Control Loop 1
Temperature Units
DEG F
DEG C
NONE
NONE
PWR FREQ
Power Frequency 60 HZ
50 HZ
60 HZ
RATIO 2
Ratio for Input 2—Set from
the front of the controller
DISABL
ENABLE
DISABL
LANGUAGE
Display Language ENGLIS
FRENCH
GERMAN
SPANIS
ITALAN
ENGLIS
3.15 Calibration Group
The prompts used here are for field calibration purposes.
3.16 Status Group
The prompts used here are read only. They are used to determine the reason for a
controller failure.