Operation
40 UDC3300 Basic Model: DC33XB User Manual 12/00
Table 4-1 Lower Display Key Parameter Prompts
Indication Description
OUT
OUTPUT #1—Output value is percent; for Three Position Step control, this is
an estimated motor position when no slidewire exists.
SP
LOCAL SETPOINT #1—Also current setpoint when using SP Ramp.
2SP
LOCAL SETPOINT #2
3SP
LOCAL SETPOINT #3
RSP
REMOTE SETPOINT
1IN
INPUT 1—Used only with combinational input algorithms.
2IN
INPUT 2
POS
SLIDEWIRE POSITION—Used only with TPSC.
CSP
COMPUTER SETPOINT—When SP is in override.
DEV
DEVIATION—Maximum negative display is –999.9.
PIDSETX TUNING PARAMETER SET 1—Selected set for single loop or primary loop
configuration where X is either 1 or 2.
ET XX.XX
ELAPSED TIME—Time that has elapsed on timer in Hours.Minutes.
TR XX.XX
TIME REMAINING—Time that remains on timer in Hours.Minutes
RAMPXXXM
SETPOINT RAMP TIME—Time remaining in the setpoint ramp in minutes.
O SK XXXX
Soak # and TIME REMAINING IN SOAK
AUX
AUXILIARY OUTPUT
SPn
SP RATE SETPOINT—Current setpoint for setpoint rate applications
BIA
BIAS—Displays the manual reset value for algorithm PD+MR.
TUNE OFF
LIMIT CYCLE TUNING NOT RUNNING—Appears when Accutune is disabled.
TUNE RUN
LIMIT CYCLE TUNING RUNNING—Appears when Accutune is enabled.
ToBEGIN
RESET SP PROGRAM TO BEGINNING OF FIRST SEGMENT
To Next Page
Loading...
