4-111
4. CONFIGURATION
4.5.2.1.2 Procedure
• Enter in PRINT mode and select the desired sub-matrix.
Press ENTER after selecting the sub-matrix.
Press SET UP to return to RUN mode.
• To confirm the PRINT mode access,
"CONFIRM" is blinking.
Press ENTER to confirm the PRINT mode access.
Press SET UP to return to the previous level.
• To define the low limit number:
The
and keys allow you to change the line numbers.
The
and keys allow you to move between both digits.
Press ENTER to confirm your choice. If your written selection is in error (non existent line number), you will
have to define a line number again.
Press SET UP to return to the initial display "PRINT CONF / ANALOG INPUT".
For example: Choose the line "05".
NOTE: Refer to section 11 "Configuration worksheet" for line limits.
PRINT CONF
ANALOG INPUT
PRINT CONF
PRINT ANALOG IN
To Next Page
Loading...
