4-112
4. CONFIGURATION
• To define the high limit number:
The procedure to define this high line number is the same as that for the low line number.
The ENTER key allows you to confirm, check and print your selection.
Press SET UP to return to the previous level.
• During the printing, the following message is displayed:
• At the end of the printing, the initial message is displayed again:
4.5.2.2 Printing the complete configuration
4.5.2.2.1 Function access
NOTICE:
TO PRINT THE COMPLETE CONFIGURATION, YOU MUST ENTER IN THE SERVICE MODE.
(For more information, see section 8 "SERVICE")
Then to access to the "PRINT ALL CONF" function:
• Enter in the SERVICE mode,
• Select the PRINT matrix.
FROM LINE 05
PRINT CONF
IN PROGRESS
PRINT CONF
ANALOG INPUT
To Next Page
Loading...
