4-113
4. CONFIGURATION
4.5.2.2.2 Procedure
• Enter in the PRINT mode.
Press ENTER to have access to this mode.
Press SET UP to return to RUN mode.
• To confirm access in PRINT mode:
"CONFIRM" is blinking.
Press ENTER to confirm access in PRINT mode.
Press SET UP to return to the previous level.
• During the printing, the following message is displayed:
• At the end of the printing, the initial message is displayed again:
SERVICE PRINTER
PR01 PR ALL CONF
PR ALL CONF
PR ALL CONF
SERVICE PRINTER
PR01 PR ALL CONF
IN PROGRESS
To Next Page
Loading...
