Configuring Network Settings
29
IPv6 Address Configuration
To enable IPv6, set IP Version to IPv6. Verify that the IP address and default gateway (router)
address are in the same network segment. Click Save to apply the settings.
ARP/Ping
You can assign an IP address to the camera using the ARP/Ping service.
To enable ARP/Ping to set the IP address:
1. Obtain an unused IP address in the same LAN as your PC.
2. Write down the MAC address of the camera (it is listed on the label).
3. Select the Enable ARP/Ping check box, and then click Save.
To Next Page
Loading...
Need help?
General
