www.honeywell.com/security
64 | Embedded NVR Bundle IP Cameras User Guide
IP Filter
Enable the IP filter function so that only the specified IP/MAC addresses can access the network
camera. You can specify an IP address or an IP address segment, such as from 192.168.1.1 to
192.168.1.100, for example. If you do not check the box to enable Tru sted Sites, then there will
be no access limitation.
Figure 3-25 IP Filter Configuration Interface
Before you can restrict access through the cameras through the IP filter, you must first configure
the Trusted Sites here.
Note You must add these addresses before enabling Trusted Sites.
Note You must set the MAC address in the same network segment as the camera’s IP
address.
To Next Page
Loading...
Need help?
General