EasyManuals Logo

Honeywell HCE80 Mounting And Operation Manual

Honeywell HCE80
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Introduction
Introduction
2
These installation and operating instructions contain all the information required for installation,
commissioning and configuring the underfloor heating controller HCE80(R) / HCC80(R).
All the operating elements and connections are shown on a fold-out page.
1
Fold out the left-hand cover.
Leave the cover folded out while reading further.
Legend for fold-out page
Fig. 1 Scope of delivery
Fig. 2 Opening the housing
Fig. 3 Display and operating elements
(1)
Power
Power supply on/off
(2) Information display
(3) Installation display
(4)
Mode
Operating mode button
(5) Installation button
(6) Pump off/off display
(7)
1...8
Zone LEDs
(8) Labelling of Zones 1...8
Fig. 4 Connections
(9) I/O
connector
(10) Switch for setting normally
open/normally closed
(11) Slot for expansion module HCS80
(12) Connector for supply voltage, pump
(13) Fuse
(14) Slot for internal antenna
(Z1...Z8) Connector for Zones 1...8
Fig. 5 I/O connector
Fig. 6 Connector for Zones 1...8
Fig. 7 Connector for supply voltage, pump

Table of Contents

Other manuals for Honeywell HCE80

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell HCE80 and is the answer not in the manual?

Honeywell HCE80 Specifications

General IconGeneral
BrandHoneywell
ModelHCE80
CategoryController
LanguageEnglish

Related product manuals