Logging In and Viewing Live Video | 21
800-22456 - A - 04/2017
Configuring the Live Interface
Note The first time you log into the web client, follow the on-screen instructions to
download and install the web browser plug-in.
You can configure the Live interface using the configuration controls located in the lower left
corner of the screen, immediately below the video window (Figure 2-2).
Figure 2-2 Live Configuration Toolbar
Table 2-1 Live Configuration Controls
Image
Adjustment
Opens the
Image Adjustment
panel.
Move the sliders to adjust the image
brightness, contrast, hue, or saturation.
Click the
–
and
+
signs to make fine
adjustments. To restore the settings to
their default values (
64
), click
Reset
.
Note
These settings only apply to the
client end. To change the settings at the camera end, go to
Setup > Camera Setup > Conditions > Picture
.
Original Size Displays the video at actual size (the exact dimensions are
determined by the stream resolution).
Full Screen
Displays the video in full-screen mode. Double-click (or press Esc)
to exit full-screen mode.
Width:Height
Ratio
Displays the video in its original size (Original) or fitted to your
screen (Adaptive).
Fluency Sets the video fluency level (Realtime, Normal, or Fluency).
Select a fluency level based on the capabilities of your network.
For example, if your connection is slow, selecting Fluency will
prioritize smoothness over image quality.
Rules Info Tracks movement in the video window when intelligent video
surveillance (IVS) is enabled (see Configuring Audio Events on
page 73).
PTZ
Opens the
PTZ
Control
,
Joystick
, and
PTZ
function panels.
To Next Page
Loading...
