Honeywell HDZ302D - Configuring Smart Plan Settings

www.honeywell.com/security
74 | equIP® Series 30x Zoom WDR PTZ Camera User Guide
9. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after an audio event has ended. Enter a value between 10 and
300.
10. To send an email notification when an audio event is detected, select the Send Email
check box. Email settings must be configured in Setup > Network Setup > SMTP
(Email). See Configuring Email Settings on page 59.
11. To initiate a predefined preset, tour, or pattern when an audio event is detected, select the
PTZ check box and select the desired action from the Activation list.
12. To take a snapshot when an audio event is detected, select the Snapshot check box.
Note For the snapshot to be attached to the email notification, the Attachment check
box must be selected in Setup > Network Setup > SMTP (Email).
See Configuring Email Settings on page 59.
13. Click Save to apply the settings.
Configuring Smart Plan Settings
You can add auto tracking or face detection to a configured preset on the Setup > IVS
Analysis > Smart Plan page. You must already have configured presets in Setup > PTZ >
Function> Preset. See Configuring Presets on page 26.
To add a smart plan to a preset:
1. Set Extensional smart function to OFF.
2. Click Add Plan and then select a preset from the list.
3. Click the icon for auto tracking or face detection to add the function to the preset.
Note You must click the currently selected icon to deselect it before making a new
selection.