Honeywell HDZ302D - Configuring Motion Detection Events

Configuring Event Settings | 69
800-22456 - A - 04/2017
Configuring Illegal Access Event Settings
An illegal access event occurs when a specified number of unsuccessful login attempts is
exceeded.
To enable illegal access detection:
1. On the Illegal Access tab, select the Enable check box.
2. In the Failed Login Attempts field, enter the number of unsuccessful login attempts
the system will allow before an illegal access event is detected. Enter a value between 3
and 10.
3. To generate an alarm output when the event is detected, select the Alarm Output check
box and select the alarm output(s) to be activated .
4. In the Alarm Delay field, enter the number of seconds that the system will continue to
generate an alarm output after the event has ended. Enter a value between 10 and 300.
5. To send an email notification when an illegal access event is detected, select the Send
Email check box. Email settings must be configured in Setup > Network Setup > SMTP
(Email), See Configuring Email Settings on page 59.
Configuring Motion Detection Events
You can configure motion detection event settings on the Setup > IVS Analysis > Video
Detection > Motion Detection page.