Honeywell HDZ302D - Configuring Tours

PTZ Operation | 27
800-22456 - A - 04/2017
Configuring Tours
To add a tour:
1. In the Tour section, below the first frame, click Add. A tour is added to the list.
2. Below the second frame, click Add. By default, Preset 1 is added to the list.
3. To change the preset, double-click the number in the Preset column, click the down
arrow to expand the list, and then select a new preset from the list.
4. To change the duration time, double-click the number in the Duration column. Type a
new duration time (in seconds), and then press Enter.
5. To add another preset to the tour, repeat steps 1 to 4. A tour must contain at least two
different presets.
6. Click Save to save the tour.
7. To preview the tour, click Start.