Configuring Network Settings | 63
800-22456 - A - 04/2017
Configuring QoS Settings
You can configure Quality of Service (QoS) settings on the Setup > Network Setup > QoS
page.
QoS settings control bandwidth use by prioritizing certain data packets over others.
To enable QoS:
1. In the Realtime Monitor field, enter a DSCP (Differentiated Services Codepoint) value
for live video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
2. In the Command field, enter a DSCP (Differentiated Services Codepoint) value for
non-video packets. Select a value between 0 (lowest priority) and 63 (highest priority).
3. Click Save to apply the settings.
Working with Certificates
You can configure certificate settings on the Setup > Network Setup > Certificate page.
To install a Honeywell-signed root certificate:
1. Click Export, navigate to the directory where you want to save the certificate (ca.crt) on
your PC, and then click Save.
2. Go to the directory where you saved the certificate and double-click the certificate. The
Certificate window opens.
3. In the Certificate window, on the General tab, click Install Certificate to open the
Certificate Import Wizard.
4. Click Next to continue.
5. Click Place all certificates in the following store, click Browse, click Trusted Root
Certification Authorities, and then click OK.
6. Click Next, and then click Finish to close the Certificate Import Wizard. A confirmation
dialog box appears with the message “The import was successful.”
7. Click OK, and then click OK to close the Certificate window.
To import a certificate or private key:
• Next to CA or Key, click Browse, navigate to the location of the certificate or key on your
PC, and then click Import.
To Next Page
Loading...
