PTZ Operation | 33
800-22456 - A - 04/2017
Operating PTZ Controls
You can access PTZ controls and functions on the right side of the Live interface window.
The PTZ Control panel consists of direction arrows, the rapid positioning button (in the
center), the PTZ speed setting, and buttons for adjusting zoom, focus, and iris settings.
A virtual joystick is also available in case you prefer to use that instead of the direction arrows.
Using the PTZ Function panel, you can access predefined functions such as autoscan,
preset, tour, pattern, and autopan. Two additional functions are Assistant and Positioning.
Assistant lets you activate an auxiliary command. Positioning lets you send the camera to a
specific position.
To use Assistant:
1. Select Assistant from the drop-down list.
2. Enter the number of the auxiliary
command that you want to send to the
camera.
3. Click Aux On to start the command.
4. Click Aux Off to stop the command.
To use Positioning:
1. Select Positioning from the drop-down
list.
2. Enter the Horizontal Angle and Vertical
Angle that you want the camera to go to
(where 1 unit of angle = 0.1 degree).
3. Click Go to.
To Next Page
Loading...
