www.honeywell.com/security
66 | equIP® Series 30x Zoom WDR PTZ Camera User Guide
To enable the alarm function:
1. Select the Enable check box.
2. From the Alarm Input list, select the alarm input that you want to configure (Alarm1 or
Alarm2).
3. Next to Alarm Period, click Setup. The Alarm Period window opens.
4. Set the days and times when you want the alarm function to be active, and then click
Save
.
5. In the
Anti-Dither
field, enter the anti-dither time in seconds. Enter a value between
0
and
100
seconds. The system will only allow one alarm event within this period.
6. Set
Sensor Type
to
NO
(normally open) or
NC
(normally closed), depending on the alarm
input type.
7. To start recording video when an alarm event is detected, select the
Record
check box.
8. In the
Record Delay
field, enter the number of seconds that the system will continue to
record video after an alarm event has ended. Enter a value between
10
and
300
.
9. To generate an alarm output when an alarm event is detected, select the
Alarm Output
check box and select the alarm output(s) to be activated.
10. In the
Alarm Delay
field, enter the number of seconds that the system will continue to
generate an alarm output after an alarm event has ended. Enter a value between
10
and
300
.
11. To send an email notification when an alarm event is detected, select the
Send Email
check box. Email settings must be configured in
Setup > Network Setup > SMTP (Email).
See
Configuring Email Settings
on page 59.
12. To initiate a predefined preset, tour, or pattern when an alarm event is detected, select the
PTZ
check box and select the desired action from the
Activation
list.
13. To take a snapshot when an alarm event is detected, select the
Snapshot
check box.
To Next Page
Loading...
