Performance Series HQA Digital Video Recorder Local User Guide
72
Figure 9-1
2. On the TCP/IP page, in the IP Version box, select IPv4 or IPv6, depending on the Internet
protocol that you want to use.
3. Set the Mode to Static or DHCP. Click Static to assign the DVR a static IP address or click
DHCP to assign it a dynamic IP address.
4. If Mode is set to Static, manually enter the IP Address, Subnet Mask, and Gateway
information. (The IP address, subnet mask, and gateway are not configurable when Mode
is set to DHCP).
5. If Mode is set to Static and you have manually entered the IP Address, Subnet Mask, and
Gateway, then click Test to test the connection.
6. If you want, enter Preferred DNS and Alternate DNS addresses.
7. Click Apply to save your settings.
8. If you want to exit the Setting menu, click Save.
To configure port settings
1. Go to Main Menu Setting Network Connection.
To Next Page
Loading...
