Performance Series HQA Digital Video Recorder Local User Guide
82
Password: Enter the authorization passwords for both the ReadOnly and Read/Write
users.
Encryption Type: Select the encryption type for both the ReadOnly and Read/Write users.
The default setting is CBC-DES and is currently the only encryption option.
Password: Enter the encryption passwords for both the ReadOnly and Read/Write users.
5. Click Apply to save your settings.
6. If you want to exit the Setting menu, click Save.
Configuring Multicast Settings
Multicast allows for simultaneous real-time monitoring of live video from the DVR at multiple
remote locations over the network.
To configure multicast settings
1. Go to Main Menu Setting Network Multicast.
Figure 9-11
2. On the Multicast page, select the Enable check box to enable multicast.
3. In the IP Address box, enter a multicast IP address. The address must be valid for
multicasting and should be in the range 224.0.0.0 to 239.255.255.255 for IPv4 or have
the prefix ff00::/8. An address in the range 239.252.0.0 to 239.255.255.255 is
recommended.
4. In the Port box, enter a multicast port number or use the default setting (36666).
5. Click Apply to save your settings.
6. If you want to exit the Setting menu, click OK.
To Next Page
Loading...
Need help?
General