Honeywell IntelliPath Series User Manual

Appendices
B-1
Appendix B: Central Station Messages
Alarm Condition
ECP Mode Zone Mode
Alarm Code Restore Code Alarm Code Restore Code
Power On / Reset E339 C08xx* 5551 5555 6
Tamper
(Compromise Indication)
E341 C08xx* R341 C08xx* 5555 5551 7 5555 5553 7
Power Loss E337 C08xx* R337 C08xx* 1555 5555 6 3555 5555 6
Low Battery E338 C08xx* R338 C08xx* 5155 5555 6 5355 5555 6
Battery Charger Failure E314 C08xx* R314 C08xx* 5155 5555 1 5355 5555 1
ECP Supervision
(Compromise Indication)
E355 C0000 R355 C0000 5555 5515 5 5555 5535 5
Primary Comm Path Supervision E350 C0951 R350 C0951 5555 5551 5 5555 5553 5
Secondary Comm Path Supervision E350 C0952 R350 C0952 5555 5551 1 5555 5553 1
Application Code Update E903 C08xx R903 C08xx
(success)
Application Code Update Failure E904 C08xx
Module Firmware Update E365 C08xx R365 C08xx
(success)
Module Firmware Update Failure E366 C08xx
Telco (Compromise Indication) 5555 5155 6 5555 5355 6
Open/Close 2 sent in selected
zone
4 sent in selected
zone
Periodic Cell Comm Test Failure E358 C0803
Test 5555 5555 9 5555 5555 9
Specific to RESIDENTIAL / COMMERCIAL Control Panels (Such as the VISTA-10P, 15P, and 20P series.)
UL
The information provided in this section for the VISTA-10P, 15P, and 20P series control panels has not
been evaluated with this communicator.
Communicator Trouble (low battery, ECP
bus, network)
(Possible Compromise Indication)
E353 C08xx* ◊ R353 C08xx* ‡
Radio Fault E353 0 1xx* ‡ R353 0 1xx* ‡
Specific to COMMERCIAL Control Panels (Such as the VISTA-128/250 series.)
Communicator Trouble (low battery, ECP
bus, network)
(Possible Compromise Indication)
E333 C08xx* ‡ R333 C08xx* ‡
Radio Loss of Signal
(Possible Compromise Indication)
E357 0 8xx* † R357 0 8xx* ‡ or
R380 0 8xx* ‡
Radio Fault (low battery, tamper, ECP
Bus)
E333 0 8xx* ‡ R333 0 8xx* ‡
AlarmNet Messages
Communication failure.
(Possible Compromise Indication)
E359 0 C950 R 359 0 C950
Authorized Radio Substitution 00D0 010C 0
Unauthorized Radio Substitution Attempt 00D0 010E 0
Service Termination 00D0 020E 0
* xx = Communicator Device Address
† = Message is sent by dialer only.
‡ = Message is sent by dialer and radio.
◊ = Message is sent by dialer only, or dialer and radio, depending
on failure.

Honeywell IntelliPath Series Specifications

General

Brand	Honeywell
Model	IntelliPath Series
Category	Cell Phone
Language	English