8 - 14
Firmware Tab
OneClick Internet selects the correct Firmware matching your operator automatically, if a special firmware for your
operator is available and a SIM card is inserted. If no specific firmware for your operator is available, generic firmware
is selected. After a firmware has been selected, it appears as the Current Profile.
You can manually load your desired firmware. Select a new firmware manually by clicking the Select New Profile
dropdown menu, selecting a firmware from the menu and tapping the Change button to load. To return to automatic
firmware selection, choose Automatic(UMTS) in the dropdown menu.
Note: Switching between CDMA and UMTS firmware is not done automatically. You must select CDMA firmware
manually to connect to CDMA networks. If you want to return to UMTS networks, you must manually select UMTS
firmware.
Activation on CDMA
When CDMA Firmware is selected, the activation of the modem on the CDMA network starts automatically. During the
process of loading CDMA firmware, an activation window pop up allowing a choice between Manual Activation and
Automated Activation.
If you cancel the activation or if it fails, you can also start the activation manually by pressing the Activate button on the
General tab.
Setting Function
Manual Activation Enter the requested items as direct by a representative from your carrier.
Automatic Activation Use your modem to start an automated activation session
To Next Page
Loading...
