Honeywell Marathon - Set All Defaults; Cancel Bar Codes

13 - 9
Set All Defaults / Cancel Bar Codes
Use the Set All Defaults bar code to return all parameters to their default values. Scanning this bar code does not affect the
Marathon operating system, wireless client or installed software settings.
Note: When the Enable / Disable Parameter Scanning (page 13-10) parameter is disabled, the scan engine can still scan the
Set All Defaults bar code. Default value of Parameter Scanning is Enable.
When parameters are changed, the new value replaces the standard default value in memory.
MicroQR Enable
QR Inverse Not Supported
Aztec Enable
Aztec Inverse Not Supported
Event Reporting
Decode Event Disable
Boot Up Event Disable
Parameter Event Disable
Symbology-Specific Security Levels
Redundancy Level Not Supported
Security Level Not Supported
Intercharacter Gap Size Not Supported
Macro PDF Not Supported
Set All Defaults
Cancel
Parameter Default Value