13 - 23
Scan Data Transmission Format
Note: Parameter "Prefix/Suffix Values" for SSI hosts should be set after setting this parameter.
Use this option when you want to append a prefix and suffix to the SSI host decode data.
If you wish to change your selection, scan the Cancel bar code and scan again.
Set the Scan Data Transmission Format parameter by scanning one of the following bar codes:
* Data As Is
[Data] [Suffix 1]
[Data] [Suffix 2]
[Data] [Suffix 1] [Suffix 2]
[Prefix] [Data]
To Next Page
Loading...
