13 - 34
Decode UPC/EAN/JAN Supplementals
Supplementals are bar codes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN 13+2).
The following options are available:
If one of the following Supplemental Mode options is selected, the bar code reader immediately transmits EAN-13 bar
codes starting with that prefix that have supplemental characters. The bar code reader transmits UPC/EAN bar codes that
do not have that prefix immediately.
Note: In order to minimize the risk of invalid data transmission, select whether to read or ignore supplemental characters.
Select an option by scanning one of the bar codes shown below. If you wish to change your selection, scan the Cancel bar
code and scan again.
Option Result
Decode UPC/EAN/JAN Only with
Supplementals
The bar code reader only decodes UPC/EAN symbols with supplemental
characters, and ignores symbols without supplementals.
Ignore Supplementals The bar code reader decodes UPC/EAN and ignores the supplemental
characters.
Autodiscriminate UPC/EAN/JAN
Supplementals
The bar code reader decodes UPC/EAN symbols with supplemental
characters immediately. If the symbol does not have a supplemental, the
bar code reader must decode the bar code the number of times set via
UPC/EAN/JAN Supplemental Redundancy” before transmitting its data to
confirm that there is no supplemental.
Option Result
Enable 378/379 Supplemental Mode ---
Enable 978/979 Supplemental Mode If 978 Supplemental Mode is selected and the decoder is scanning
Bookland EAN bar codes, see Bookland EAN (page 13-32) to enable
Bookland EAN, and select a format using Bookland ISBN Format (page
13-33).
Enable 977 Supplemental Mode ---
Enable 414/419/434/439 Supplemental
Mode
---
Enable 491 Supplemental Mode ---
Enable Smart Supplemental Mode Applies to EAN-13 bar codes starting with any prefix listed previously.
Supplemental User-Programmable Type 1 Applies to EAN-13 bar codes starting with a 3-digit user-defined prefix.
Set this 3-digit prefix using Supplemental User-Programmable 1.
Supplemental User-Programmable Type 1
and 2
Applies to EAN-13 bar codes starting with either of two 3-digit user-
defined prefixes. Set the 3-digit prefixes using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Smart Supplemental Plus User-
Programmable 1
Applies to EAN-13 bar codes starting with any prefix listed previously or
the user-defined prefix set using Supplemental User-Programmable 1.
Smart Supplemental Plus User-
Programmable 1 and 2
Applies to EAN-13 bar codes starting with any prefix listed previously or
one of the two user-defined prefixes set using Supplemental User-
Programmable 1 and Supplemental User-Programmable 2.
Supplemental User-Programmable 1 Select Supplemental User-Programmable 1 to set a 3-digit prefix. Then
select the 3 digits using Imager Keypad Number Symbols (page 13-84).
Supplemental User-Programmable 2 Select Supplemental User-Programmable 2 to set a second 3-digit prefix.
Then select the 3 digits using Imager Keypad Number Symbols (page 13-
84).
To Next Page
Loading...
