13 - 43
Convert UPC-E to UPC-A
When this parameter is enabled, UPC-E (zero suppressed) decoded data is converted to UPC-A format before transmis-
sion. After conversion, data follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble,
Check Digit, etc.).
When disabled, UPC-E (zero suppressed) decoded data is transmitted without conversion.
Select an option by scanning either of the bar codes shown below.
Convert UPC-E1 to UPC-A
When this parameter is enabled, UPC-E1 (zero suppressed) decoded data is converted to UPC-A format before transmis-
sion. After conversion, data follows UPC-A format and is affected by UPC-A programming selections (e.g., Preamble,
Check Digit, etc.).
When disabled, UPC-E1 (zero suppressed) decoded data is transmitted without conversion.
Select an option by scanning either of the bar codes shown below.
EAN-8/JAN-8 Extend
When this parameter is enabled, five leading zeros are added to decoded EAN-8 symbols to make them compatible in for-
mat to EAN-13 symbols. Use parameter “Convert EAN-8 to EAN-13 Type” to label the extended symbol.
When disabled, EAN-8 symbols are transmitted as is and parameter “Convert EAN-8 to EAN-13 Type” setting is ignored.
Enable UPC-E to UPC-A
* Disable UPC-E to UPC-A
Enable Convert UPC-E1 to UPC-A
* Disable Convert UPC-E1 to UPC-A
To Next Page
Loading...
