13 - 64
Next, scan four numeric bar codes that correspond to the desired value. Single digit numbers must have a leading
zero. To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Length Within Range
This option decodes a code type within a specified minimum and maximum range. For example, when you want to
scan only Codabar symbols containing between 4 and 12 characters, scan the Codabar Length Within Range bar code
and then “0”, “4”, “1” and “2” bar codes using Imager Keypad Number Symbols (page 13-84).
To begin setting lengths within a range, scan this Codabar Length Within Range bar code:
Next, scan numeric bar codes that correspond to the desired value using Imager Keypad Number Symbols (page 13-
84). Single digit numbers must have a leading zero. To correct an error or to change a selection, scan Cancel on the
Imager Keypad Number Symbols page.
Any Length
This option decodes Codabar bar codes containing any number of characters.
To set any length, scan this Codabar Any Length bar code:
To Next Page
Loading...
