6 - 25
WPA/LEAP
To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile
2. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set Auth Type to Open.
• If the AP is configured to use shared key or passphrase, set Auth Type to Shared.
3. Set WPA as follows:
•Select WPA/WPA2 to use either TKIP/AES or AES-CCMP
•Select WPA2 to use AEX-CCMP
4. Set Encryption to either TKIP/AES or AES-CCMP depending on WPA type selected
5. Set Authentication to LEAP
See Sign-On vs. Stored Credentials (page 6-12) for information on entering credentials.
Scroll down to enter credentials. No entries are necessary for Sign-On Credentials as the user will be prompted for the
Username and Password when connecting to the network.
Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
Enter the password.
To Next Page
Loading...
