6 - 47
Custom Option
Honeywell does not support the Custom option. The value is displayed as “Custom” when the operating system regis-
try has been edited to change the Summit setting to a value that is not available from the settings drop down list.
Selecting Custom from the drop down list has no effect. Selecting any other value from the drop down list will overwrite
the “custom” value in the registry.
Global Settings
Setting Default Function
Roam Trigger -65 dBm If signal strength is less than this trigger value, the client looks for a different Ac-
cess Point with a stronger signal.
Options are: -50 dBm, -55, -60, -65, -70, -75, -80, -85, -90 dBm or Custom
Roam Delta 5 dBm The amount by which a different Access Point signal strength must exceed the
current Access Point signal strength before roaming to the different Access Point
is attempted.
Options are: 5 dBm, 10, 15, 20, 25, 30, 35 dBm or Custom
Roam Period 10 sec. The amount of time, after association or a roam scan with no roam, that the radio
collects Received Signal Strength Indication (RSSI) scan data before a roaming
decision is made.
Options are: 5 sec, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 seconds or Custom.
BG Channel Set Full Defines the 2.4GHz channels to be scanned for an AP when the radio is contem-
plating roaming. By specifying the channels to search, roaming time may be re-
duced over scanning all channels.
Options are:
Full (all channels)
1,6,11 (the most commonly used channels)
1,7,13 (for ETSI and TELEC radios only)
Custom
DFS Channels Off Support for 5GHZ 802.11a channels where support for DFS is required.
Options are: On, Off.
Not supported (always off) in some releases.
DFS Scan Time 120 ms. ABG radio only. The amount of time the radio will passively scan each DFS
channel to see if it will receive a beacon.
Recommended value is 1.5 times that of the AP's beacon period.
To Next Page
Loading...
