Honeywell MeshGuard FTD-2000 - MeshGuard Programming Mode

MeshGuard User’s Guide
17
5.4 Programming Mode
Programming Mode allows you to perform any of the following actions (listed in order of appearance):
• Calibrate the MeshGuard
• Changing Preset Limits or Span Gas Values
• Set Pan ID
• Join network
• Choose communication interval
The menus accessed in Programming Mode are:
• Zero Calibration
• Span Calibration
• High Alarm
• Low Alarm
• STEL (Portable Mode only)
• TWA (Portable Mode only)
• Set Span Value
• Pan ID
• Join Network
• Communication interval