MeshGuard User’s Guide
6.3.5 Calibration Delta Counts
Calibration Delta CTS is indicated by “CdC” followed by a number.
• Press [N/-] to return to the first raw count.
6.4 Diagnostic Mode Programming
You can enter a special programming mode from Diagnostic Mode in order to perform advanced programming
functions. These include:
• Enable Portable Mode
• Enable Radio
• Enable STD or RTR
• Return MeshGuard to original factory settings
• Enable/disable audible and visible alarms
Note: When the MeshGuard is in this programming mode, if you do not make a change or press a key for 60
seconds, it reverts to the standard Diagnostic Mode.
Important! After you make changes in Diagnostic Mode, it is recommended that you turn off the MeshGuard and
turn it on again before using it.
To Next Page
Loading...
