Honeywell MeshGuard FTD-2000 User Manual

MeshGuard User’s Guide
18
5.4.1 Entering Programming Mode
To enter the Programming Mode, press [MODE] and [N/-] for 3 seconds. “Pro” appears in the display:
Pressing [N/-] steps you through all the screens and then returns to the first programming display:
Each display alternates between its name and a status message or value.
Note: You can exit Programming Mode at any time by pressing [MODE]. Also, if you do not make a change within
one minute, the MeshGuard exits Programming Mode and returns to Detection Mode.

Honeywell MeshGuard FTD-2000 Specifications

General

Brand	Honeywell
Model	MeshGuard FTD-2000
Category	Monitor
Language	English