MeshGuard User’s Guide
6.4.1 Fixed Or Portable Operation Selection
The first menu is for setting the MeshGuard for fixed or portable operation. In Portable Mode, STEL, TWA, and
Peak readings are included.
“SEt” and “ Ptb” flash in alternation, to indicate that the MeshGuard can now be set as fixed or portable. The default
value is “fixed.”
Press [Y/+] to enter and change the setting, [MODE] to exit and return to Detection Mode, or [N/-] to go to the next
menu.
The LCD displays the current value (enabled or disabled). Change the value if necessary by pressing [Y/+] or [N/-].
Press [MODE} to enter your selection. Press [Y/+] to accept at this screen.
Note: “dIS” means fixed (Portable Mode disabled) and “En” means portable (Portable Mode enabled).
6.4.2 Radio Enable/Disable
The next menu is for setting turning the MeshGuard’s radio on or off.
“SEt” and “ rdo” flash in alternation, to indicate that the MeshGuard radio can be turned on (enabled) or off
(disabled). The default value is “on.”
Press [Y/+] to enter and change the setting, [MODE] to exit and return to Detection Mode, or [N/-] to go to the next
menu.
The LCD displays the current value (enabled or disabled). Change the value if necessary by pressing [Y/+] or [N/-].
Press [MODE} to enter your selection. Press [Y/+] to accept at this screen.
Note: “dIS” means disabled (radio off) and “En” means on (radio on).
6.4.3 Std Enable or Rtr Enable
Press [Y/+] to toggle the setting from Std to Rtr, and vice versa. Refer to “Operation Modes” on page 13.
To Next Page
Loading...
Need help?
General